1.Click menu access control.

2.Click and expand "Alarm Function", and click "Anti Theft Alarm".

3.Face machine and fingerprint machine do not support anti-theft alarm setting, nor do they support stopping alarm.

4. The anti-theft host can only start the anti-theft monitoring after continuously reading the card for 3 times (or by opening the password) through the management card. If someone is monitored, the alarm will be delayed for N seconds. (If someone reads the management card twice in N seconds, it can be cancelled or cancelled by closing the password)

5. Entry delay: the time before the anti-theft host enters the deployment state after brushing the anti-theft setting card three times or entering the deployment password. This time is the time waiting for the personnel to leave the site. When the time arrives, it enters the anti-theft deployment state; At this time, after the infrared probe is triggered again, the alarm delay will be entered.

6. Arming password: the password for the anti-theft host to start arming status.

7. Arming password: the password for the anti-theft host to start arming.

8. Anti theft password: the password for the anti-theft host to turn off the arming status.

9. Alarm duration: the time to drive the alarm bell. After the alarm, the alarm will be automatically released and the arming state will be re entered.

10. Check the access control equipment to be operated, click the OK button, set the anti-theft host deployment function switch, and synchronize to the equipment within 30 minutes after the equipment is online.